leBipBip+ Manual

Home/leBipBip+ Manual
leBipBip+ Manual 2017-09-11T10:37:41+00:00

leBipBip+ User Manual

ON : turn ON leBipBip+ by a simple short click on the button, you will hear the start up tone.

OFF : turn OFF leBipBip+ by a 2 seconds click on the button.

Note : If you hear only one beep when you turn the device ON, it means that it needs to be recharged under the sun.

You can select four different volumes with a short click on the button :

  • minimum
  • medium
  • maximum
  • LED with vario silent

Weak lift buzzer : short modulations indicating weak lift (between -30cm/s and your +lift threshold, default +20cm/s), not strong enough to thermal but helping you to find thermal nearby.

Double click anytime when the device is ON to activate or deactivate the feature.

You can change the Sink alarm settings at any time, even just before take off, following the diagram above.

To enter the sink alarm settings menu :

  1. Switch the leBipBip+ OFF
  2. Keep the button pressed at least 4 seconds
  3. Then, every simple click changes the setting
  4. Validate your choice by a 2 seconds click

You can change the lift settings at any time, even just before take off, following the diagram above.

To enter the vario settings menu :

  1. Switch the leBipBip+ ON
  2. Keep the button pressed at least 4 seconds
  3. Then, every single click, the lift setting changes
  4. Double-click to change from fast-to-slow or slow-to-fast reactivity
  5. Validate your choice by a 2 seconds click

Sensitivity :

This is the lift threshold, in cm/s, level when the vario will start beeping.

Reactivity :

How quick the vario react after entering the thermal.

eg: either fast for tight mountain thermal, or slow for large flatland lift.

leBipBip+ is always charging while under the sun ! It will take about 10h of direct full sun to charge it completely.

When the battery level is low (20%), the LED blinks red. It indicates that you should leave the device under the sun to recharge it.

Note : do not place the device behind a window, or the windshield of a car, leBipBip+ won’t charge, and the battery could be damaged.

2 loop velcros are provided for you to fix leBipBip+ to your equipment.
You can either stick a velcro at the back of your helmet, and if needed, the other one on your harness shoulder strap.
If you need to see leBipBip+ LED, you can fix it directly to your cockpit, or use the two velcros sticked to one another around the risers.

Note : Make sure to place leBipBip+ at the back of your helmet, not on the side, in order to avoid erratic beeps due to variations of the airflow (for example, when the pilot turns his head).

If needed, proceed to a factory reset anytime by pressing the button for about 20 seconds : default settings will be applied.

Here, download the printable user manual version

Download manual page 1

Download manual page 2

Or save it on your smartphone in picture format

Download manual page 1

logo_png

Download manual page 2

logo_png