• Download voice pack and firmware
• Connect your leGPSBip as a disk to your computer

  (see section “file transfer and charge” on the manual)
• Delete the file named config.gpsbip located at the root of leGPSBip
• Place the voice pack file into the folder named ‘voices’ on your leGPSBip
• Place the firmware file at the root of leGPSBip
• Click on ‘Eject disk’
• Still USB connected, switch your leGPSBip on, and wait for the vocal confirmation ‘updating, please wait’
• Disconnect leGPSBip, and select language

  (one simple click to change, 2s click to select)
• In order to get the Instant Vario, proceed manually to the sensors calibration

  You need to follow the vocal informations and the calibration procedure :

  CLICK HERE TO FOLLOW THE CALIBRATION STEPS.
• Once you have done the calibration, the update is complete !
• Once you have done the calibration, the update is complete !

  Note : calibration must be done only once, for the first update. For the following updates, sensors stay calibrated.

1. Download the voice pack file
   
2. Connect your leGPSBip+ as a disk (see section “file transfer and charge” on the manual) to your computer.
   
3. Replace the old file by the new downloded one inside the folder named “voices”
4. Keep your leGPSBip+ connected until it stops blinking, and then click on Eject disk
   
5. Disconnect leGPSBip+ and turn it ON
   

There should always be at least one voice pack in the “voices” folder.

1. Switch off your leGPSBip+
   
2. Connect it to your computer
3. Open leConfigurator
   
4. Click on “load config”, and follow the instructions
5. The version number will be available under System > more (see screenshot below)

In case of difficulty, you can enter in recovery mode with the following procedure:

1. Connect your leGPSBip via USB to your computer
   
2. Hold the button pressed for 30s
3. Download this file
4. Place the file at the root of the disk
5. Keep your leGPSBip connected until it stops blinking, and then click on Eject disk
6. Still USB connected, switch your leGPSBip on, and wait for the steady green LED for 5sec then the ascending start-up tone.
7.  You can now install the latest update

Version 3.29 (2022-05-03)

Version 3.28 (2020-09-02)

• KML tracks issue fixed: negative with leading 0 issue (eg: around Equator)
• vario led sink red fixed
• pressure sensor bug fixed
• voice pack: added “en_av”: added avionic voicepack with altitude in feet but sink/lift in m/s

Version 3.27 (2020-07-10)

• Vario LED: fix sink red freeze and no orange detector
• Sensor: better error handling

Version 3.25 (2020-05-27)

• take off detection: improve detection
• landing detection: new feature, default on
• pressure sensor unresponsive in sink fix

Version 3.24 (2020-03-02)

• Voice climb rate from average lift (integrated vario 15/20sec)

Version 3.23 (2020-02-20)

• Vario takeoff detection based on average vario at 175cm/s

Version 3.22 (2020-02-17)

• Fix KML file: lat/long -0 issue withing 0/-1 range (equator KML file sign error, not IGC)

Version 3.21 (2019-10-04)

• Update to GCC 2019 compiler

Version 3.20 (2019-09-23)

• Vario mute when button pressed
• Altitude > 5km with new voicepack

Version 3.13 (2019-05-10)

• Vario led fix issue

Version 3.12 (2019-05-01)

• Autopower off when no GPS (based on vz only and time)

Version 3.11 (2019-01-21)

• Battery monitor fix at 0% at startup error

Version 3.10 (2018-11-08)

• Vario tone : tone generation, contiunous tone and sink alarm
• Configurator : improvement : various options
• Configuration file : “Updating, please wait” at the first 2 startups
• Config file : fix firmware/lang pack version update if present
• Language selection : fix : at startup only when needed

Version 3.09 (2018-09-18)

• Vario : instant vario with accelerometer and gyroscope sensors
• User calibration mode
• Battery level : speaks 0%
• Factory default : hold button menu

Version 2.2 (2017-04-24)

• option for compatibility with Kobo in the Configurator
• pre-shutdown confirmation tone to prevent inadvertate power off
• backup config file after a reset is now called before-reset-config.gpsbip instead save_config.gpsbip
• sink alarm vario glitch fixed
• new install file format includes the latestet version of Configurator
• large GPS tracking perdiod (> 10sec) behaviour improved
• vario silent reactivated when low battery reached bug fixed
• USB power off when charged and not used
• KML: G force max
• KML: flight summary cleanup
• KML line witdh 3 instead of 2
  
• IGC file error if KML disabled
• Solar charge status and battery level at startup

Version 2.0.5 (2016-12-01)

• FAI/CIVL IGC valid with XSD signature
• Timezone in minute for India and other specific timezone
• Vario sweep tone glitch
• Vario filter init startup
• Barometric altitude GPS correction even before takeoff
• Config file detection improved
• Autoshutdown fixed
• GPS reception in high performances when USB powered
• Takeoff detection
• Sink alarm setting and issue
• Kobo Glow compatibility
• Track folder YYYY/MM/DD
• KML file: altitude jump, track with pilot name, position rounding
• IGC file: barometric altitude sign
• Mac OS X: eject device without remount
• Vario: integration time: slow and fast available
• Altitude barometric with NOAA
• Double tap detection patern
• Auto voice mode toggle (triple click) fix
• Sink alarm disable regression fix

Version 1.0.7 (2016-07-25)

• GNSS position issue in Q3/Q4
• LK8EX1 protocol temperature added
• Fix barometric altitude around sea level
• Export voice.pack number
• Kobo automatic reconnection
• IGC flight date legacy compatibillity
• Double tap sensitivity decrease
• Vario volume medium at lower volume
• Voice tap can be disable until take off
• Voice tap available with double click if vario disabled
• GPS negative altitude issue, not supported in IGC file format
• LK8EX1 vario sign issue
• UTC offset
• Vario silent on ground
• Vario glitch when silent
• Firmware version recorded in IGC and KML file
• Led green fix at power up
• KML track in 3D or 2D mode
• Voice manual: double click when vario silent
• Speak on config file change
• Timezone setting in configurator
• Timezone in IGC and KML files
• Configurator import compatibility
• Kobo/External battery detection
• Configurator installation from .install updates
• Voice pack (1) (2) rename
• Vario tone glitch after updates
• GPS wait for 3D fix before low power mode
• Shutdown when battery low
• Dont startup when battery low
• LK8EX1/GPSBip protocol Vz value fix