leGPSBip calibration procedure

/leGPSBip calibration procedure
leGPSBip calibration procedure 2020-03-04T10:22:09+00:00

Извините, этот техт доступен только в “Американский Английский” и “Французский”. For the sake of viewer convenience, the content is shown below in this site default language. You may click one of the links to switch the site language to another available language.

The instant vario feature requieres a user calibration for best performance.

Help of another object will help you achieving the correct orientation. It can be a pen, book, rubber eraser, or anything else.

Calibration procedure will start automatically when upgrading to V3.x.

Make sure to perform this setup on a perfectly flat table, and in a very calm environment (no vibration, no music, no one walking on the floor, etc…).

SETUP

Once the update is done, follow the following procedure, step by step :

STEP 1

  • Turn on the device, and wait for the start tone.
  • Lay down the device with the solar panel facing up.
  • Don’t move, and wait for the high pitch validation tone.

STEP 2

  • Change the position : lay it down with the USB connector facing up (WARNING : do not press the button).
  • Don’t move, and wait for the high pitch validation tone.

STEP 3

  • Change the position : lay it down with the velcro facing up.
  • Don’t move, and wait for the high pitch validation tone.

STEP 4

  • Change the position : lay it down with the button facing up.
  • Don’t move, and wait for the high pitch validation tone.

STEP 5

  • By using an object (like a pen), lay it at a 45° angle with the solar panel and handle facing up (we recommend to use a second object to avoid it to rip).
  • Don’t move, and wait for the high pitch validation tone.

STEP 6

  • Change the position : lay it at a 45° angle with the solar panel and speaker grid facing up.
  • Don’t move, and wait for the high pitch validation tone.

STEP 7

  • Change the position : lay it at a 45° angle with the USB connector and speaker grid facing up.
  • Don’t move, and wait for the high pitch validation tone.

STEP 8

  • Change the position : lay it at a 45° angle with the button and speaker grid facing up.
  • Don’t move, and wait for the high pitch validation tone.

STEP 9

  • Change the position : lay it at a 45° angle with the button and handle facing up.
  • Don’t move, and wait for the high pitch validation tone.

STEP 10: repeat STEP 1 to 9

Once this calibration sequence made, start over with the validation sequence, from STEP 1 to STEP 9  one more time.

A success rising tone will inform you of correct calibration.